Generac Power Systems MAGNUM MLT6SKDS Owner's Manual page 26

General Information
Scheduler Screen
NOTE: This feature will only work in AUTO mode.
See Figure 2-22. The Scheduler screen allows the
operator to program specific times for the lights to turn on
and off. Once programmed, the Scheduler will start the
engine and illuminate the lights until the designated
shutdown time.
Figure 2-22. Scheduler Screen
Maintenance Screens
See Figure 2-23. The information displayed on the
maintenance screens can be used to identify, diagnose,
and troubleshoot unit shutdown conditions and poor unit
performance.
Figure 2-23. Maintenance Screens
Icon Description
Home screen
Alarms screen
Maintenance screen
22
Icon Description
Event log screen
About screen
Proceed as follows to enter the navigation menu:
1. Press both the ↑ and ↓ buttons simultaneously.
2. To select the required icon, press the ↑ button to
cycle right and the ↓ button to cycle left until the
desired operator screen section is reached.
3. Press the Select () button to enter the desired
operator screen section.
NOTE: Every time the operator screens are entered, the
home icon will be located at the top of the screen.
Home Screens
See Figure 2-24. The Home (
screen of the controller and displays after the controller
has powered up. The controller automatically returns to
Home screen from any other screen after a period of
inactivity.
002329
Figure 2-24. Home Screen (MANUAL Mode Shown)
Alarms Screen
See Figure 2-25. The Alarms (
alarms, warnings, and engine Diagnostic Trouble Code
(DTC) faults. When an alarm occurs, the controller
automatically switches to this screen and remains there
until the alarm is cleared. The Stop LED also flashes.
003779
Owner's Manual for MLT6SMDS - MLT6SKDS Light Tower
) screen is the default
) screen displays all the
Figure 2-25. Alarms Screen
002544
003780