Draining - Pogo 36 Owner's Manual

- Unscrew the tiller block:
You must now loosen the screw of the tiller block.
- Remove the axis of the block:
WARNING
the rope, previously installed.
To consolidate the axis it's better to slightly lift the rudder with help of the retaining
rope. Once the axis consolidated you can remove the axis and disengage the rudder.
Remark: A rudder weighs 14kg and it doesn't float!

7. Draining

The draining system of a Pogo 36 contains an electrically operated bilge pump, situated in the
technical zone, as well as a manual bilge pump, operated from the starboard coaming, in the cockpit.
These two pumps share the same aspiration tubing, rolled, situated in the technical zone. A filter is
provided just ahead of the pump.
In case of damage, leaking, or just to dry the bottom of the vessel, unroll the water hose in the
technical zone, to be able to access to any part of your boat.
It is recommended to check the function of each pump regularly, as well as the clogging of the filter.
The total capacity of the bilge pump system is not designed to drain the boat in case of a significant
hull damage.
this is the last step, once this axis is removed the rudder will only be held by
13