Pogo 36 Owner's Manual page 13

WARNING: if you are at sea, be sure that the auto pilot is turned off and on rudder mode, or that one
person keeps the rudder completely firm, as you are operating on moving parts that could crush a
body limb.

disconnect the rudder bar, unscrew all the bolts along the rudder-shaft,

make sure the rudder is supported (by a rope) and only then, remove the tiller block.
At this time, only the tiller block is supporting the rudder, if you want to remove it
you first have to secure the rudder to be sure that you won't lose it once you have
removed the axis of the block.
There is a tapped hole on the head of the stock to be able to screw a M6 screw, in
order to fasten a retaining rope (for instance a halyard).
M6 Tapped hole
Tiller block
Axis of the tiller block
- Unscrew the tiller block wedge clamp:
Loosen and turn the wedge clamp, to be able to clear the passing of the screw during the
lowering of the rudder.
Retaining rope
M6 Screw
Tiller block wedge clamp
Tiller block screw
Unscrew the 2 screws
indicated to the left. Screw
M10 (key N° 17)
Remove the screw passing
through the stock.
The rudder stock lever is now
free from the stock.
12