Table of Contents
Advertisement
4） ADJUSTMENTS AND CHECKS BEFORE USE
Before using the machine, please check if the rail and components installed on the machine is suitable for the screw applied. The rail is φ 1.0
to φ 3.0 depending on the nominal diameter. It is determined by the identification seal on a rail front cover. There are two kinds of passage
plates, namely one for φ1.0 to φ1.7 and one for φ2.0 to φ3.0. It is determined by an identification seal affixed on a passage plate.
◆ When there is no rail installed on the machine, please install the rail before use.
First, unfasten the rail fixing bolt through the upper bit guide holder.
Insert the rail into the furthest point.
Fasten the fixing bot.
◆ Quantity of screws thrown in
If too many screws are thrown in, orientation and transfer of the
screws will be seriously affected. See the diagram on the right for the
maximum number of the throw screws in the [scooping chamber].
• Set the [scooping block] in the lowest possible position.
• Throw in screws up to a position of 2 mm to 3 mm below the rail groove face.
• In this condition, ensure that the front inclined-face of the ramp is
not hidden by the screws.
Ensure that the rail groove face is not hidden by the screws.
(Screws should be positioned 2 to 3 mm below the rail groove.)
These parts of the inclined face of the ramp should be use underline.
- 4 -
Advertisement
Table of Contents
