Table of Contents
Advertisement
5） OPERATING INSTRUCTIONS
◆ Supplying screws (Refer to P. 4)
• Set the [scooping block] to the lowest possible position. Remove the top cover of the [scooping chamber]. Throw in screws
up to a position of 2 mm to 3 mm below the rail groove top face.
• In this condition, ensure that the front inclined-face of the ramp is not hidden by the screws.
Caution: An excessive quantity of screws thrown in may cause a machine malfunction.
◆ Switch-on
• Plug the provided AC adapter into a wall outlet and into the machine.
• Turn on the power switch. The power switch lamp will light up.
• The up-and-down movement of the scooping block and back-and-forth movement of the rail will activate.
• Subsequently, screws are successively sent to the outlet direction. Unless you pick up the screws in the stopper section, the
sensor senses it and the machine stops operation.
• If you pick up the screws in the stopper section, the sensor senses it and the machine resumes operation.
◆ Picking up screws
• When picking screws up, use a bit that fits the screw diameter and groove width of the holding plate.
• Make a motor-driven driver's bit upright, put it down to the vertical direction along the V groove of the bit guide while
turning it, and pull it out toward yourself when cross recess on the screw head.
Caution: Do not exert any excessive force to the rail at this time. It may cause the machine to malfunction.
◆ Timer settings (Refer to P. 11)
• If you pick up screws of the stopper section and then do not pull up the next screws for a certain period of time, the machine
stops. Operation will resume again after you pick up screws.
• The time until the machine stops is adjustable within 1 to 6 seconds. Adjust it according to the procedure in the diagram on the right.
Caution: Always unplug the AC adapter from the wall outlet before making any adjustments to avoid injury.
- 12 -
Advertisement
Table of Contents
