Advertisement
TG509F,G VERSAGUARD™ UNIVERSAL THERMOSTAT GUARDS
Remove the paper backing and clear protective
cover from the monogram included. Place the
monogram in the recessed area on the guard cover.
See Fig. 4.
NOTE: The thermostat guard is shipped with an
allen wrench secured in the top notch of
the ring base. When thermostat calibration
is needed, remove the Versaguard™ cover
and use the wrench to remove the top two
allen screws in the thermostat cover. This
allows servicing of the thermostat while the
ring base is in place.
RING BASE
Fig. 2. Mount guard cover.
RING BASE
KEY
Fig. 3. Lock thermostat guard.
Home and Building Control
Honeywell Inc.
Honeywell Plaza
P.O. Box 524
Minneapolis, MN 55408-0524
69-1008—1
69-1008—1 J.S. 1-97 Printed in U.S.A
COVER
M15010
COVER
M15009
Home and Building Control
Honeywell Limited-Honeywell Limitée
155 Gordon Baker Road
North York, Ontario
M2H 2C9
2
REMOVE
PAPER
BACKING
1 TURN MONOGRAM 90 DEGREES
ON VERTICALLY MOUNTED GUARDS.
Fig. 4. Apply monogram to thermostat guard.
Remove Thermostat Guard
Remove the thermostat guard cover by inserting the key
provided and turning the key clockwise until the locking
mechanism is disengaged. See Fig. 5.
RING BASE
Fig. 5. Remove thermostat guard cover.
CHECKOUT
Before leaving the installation, refer to the applicable
instructions to check the operation of the thermostat and
ensure that the guard is in the locked position.
MONOGRAM
REMOVE
CLEAR
PROTECTIVE
COVER
1
PLACE MONOGRAM
IN RECESSED AREA
ON GUARD COVER
M15011
COVER
M15012A
Helping You Control Your World
®
Advertisement
