Connecting Your Lcd Monitor - Samsung 770TFT, 870TFT, 170T Owner's Instructions Manual

Setting up Your LCD Monitor

Connecting Your LCD Monitor

This monitor offers a method for connection to both a PC and a workstation. One or both
types of signal cables can be connected to the monitor simultaneously. Determine which
connection method(s) you need and refer to the instructions below.
Figure 3.1 Cable Connection (Analog)
1
Turn off your computer and unplug its power cord.
2
Connect the signal cable to the 15-pin, D-sub connector on the back of your monitor.
3
Connect the signal cable to the video port on your computer, video board, video card,
or graphics card.
4
Connect the power cord for your monitor to the DC adapter and connect the adapter
jack to the DC power port on the back of your monitor.
5
Plug the computer and monitor power cords into a nearby power mains outlet.
6
Turn your computer and monitor on. If your monitor displays an image, it has been
successfully installed.
7
If necessary, install the video driver for this monitor (see "Installing the Video Driver"
on page 7).
8
After your monitor has been fully installed, run Auto Adjustment (see page 12).
2
4
English
3
4
5
5
4