• Climate, corrosion or misuse could result in system failure. Goalsetter Systems, Inc. reserves the right to make changes at any • Only use parts provided with your Goalsetter basketball goal ®...
116” 116” * Dimensions (F) and (G) do not apply to fixed height goals. IMPORTANT Goalsetter Systems, Inc. cannot assume liability for the installation Systems recommends of any wall-mounted structure. Goalsetter ® consulting a professional architect or contractor to determine a safe wall anchoring system to match the wall construction being used in your application.
Frame attachment IMPORTANT WARNING • Bottom of frame should be 88” up from playing surface. This Two or three people in good physical condition and capable of lifting at least 90-100 lbs. (40-45 kg) each are recommended for is needed to achieve full range of goal height adjustability. safe installation and assembly.
Frame assembly adjustable Height Goals only Step 4: Attach upper mount of jack assembly to jack WARNING mount clevis on upper extension arm using the following: Two or three people in good physical condition and capable of one upper jack pivot bolt, two flat washers, and locknut. lifting at least 90-100 lbs.
Frame assembly Fixed Height Goals only Step 5: Attach upper mount of stabilizer bar to jack WARNING mount clevis on upper extension arm using the following: Two or three people in good physical condition and capable of one upper jack pivot bolt, two flat washers, and locknut. lifting at least 90-100 lbs.
Backboard attachment Step 2: Carefully lift the backboard from the box and WARNING align upper backboard holes with upper extension arm Backboards can weigh between 168 lbs. to 266 lbs. Two or holes using the following software: two backboard bolts, four three people in good physical condition and capable of lifting flat washers, and two locknuts.
rim attachment NOTE: Use all steps of the following instructions to install a reflex Step 2: If not already removed, remove cover plate rim. To install a static rim, follow all steps except Steps 2 and 6. screws and cover plate from rim assembly. Step 3: Starting with the top two mounting holes, TIME OUT TIP: Your warranty card is located...
raise and adjust Backboard Fixed Height Goals only Step 4: Lengthen or shorten the stabilizer bar by WARNING! turning it ½ turn for every ¼” of adjustment needed (or 1 full turn To prevent serious injury or death, if using a stepladder, make for every ½”...
Height Indicator attachment adjustable Height Goals only Step 3 Step 1 Step 1: Position top of rim 10’ above playing surface by 10’ turning crank handle. Step 2: Measure distance with a tape measure for accuracy. Step 3: Align height indicator bar decal with 10’ mark on frame and attach to bottom of upper extension arm.
• Contact Goalsetter Systems, Inc. for replacement parts. Only A general-purpose lubricating oil like “3-in-1” or lightweight use parts provided by Goalsetter Systems, Inc. Use of other motor oil is recommended. DO NOT use a penetrating oil (i.e. parts (a) may cause the goal system to fail, (b) could result WD40.) Goalsetter has “Maintenance Kits”...
Goalsetter Systems, Inc. warranty; A11200 Easy-Up Youth Mini Goal: 1-year limited warranty on structure and rim, limited lifetime warranty needs your warranty item returned. Goalsetter Systems, Inc. will notify you by fax or phone if we determine that the on backboard item cannot be claimed under warranty.