TP-Link T1500G-10MPS Installation Manual page 10

JetStream Smart Switch
LED Mode Switch Button
Press this button to switch the LED status indication between Speed and PoE.
Reset
With the switch powered on, press Reset button for 5 seconds to reset the software setting to its factory
default settings.
Unit ID LED
Designed to display the stack Unit ID of the switch. For the switch that does not join any stack system,
it displays its default Unit ID. To modify the default unit number, please logon to the GUI of the s w i t c h
and go to Stack→Stack Management→Stack Config page and configure the New Unit ID. The new Unit
ID will take effect after you reboot the switch.
10/100Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps or 100Mbps.
10/100/1000Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps.
SFP Port
Designed to install the SFP module. For T1500, T1500G and T1600G series products, the switch
features some slots that are shared with the associated RJ45 ports. The associated two ports are
referred as a "Combo" port, which means they cannot be used simultaneously, otherwise only SFP port
works.
SFP+ Port
Designed to install the SFP module. For T1700G-28TQ and T1700X-16TS, the switch supports 1G or
10G SFP module connection.
Port Feature
100M/1000M/10Gbps
Model
T1500-28TC
T1500-28PCT
T1500G-10MPS
T1600G-18TS
T1600G-28TS
T1600G-28PS
T1600G-52TS
T1600G-52PS
T1700G-28TQ
T1700X-16TS
06 Introduction
10/100/1000Mbps
RJ45 Port RJ45 Port
0
0
0
0
0
0
0
0
0
12
10/100Mbps RJ45
Port
4 24
4 24
8 0
16 0
24 0
24 0
48 0
48 0
24 0
0 0
SFP Port SFP+ Port
2 0
2 0
2 0
2 0
4 0
4 0
4 0
4 0
0 4
0 4