Navigation; Settings Mode - Dimplex UP 75-25PK Installation And Operating Instruction

English

6.2 Navigation

Key lock
Locking the control keys is intended to prevent the settings from
being changed by mistake or without authorization.
If the key lock is activated, it is not possible to switch to settings
mode. It is still possible to switch to the settings view, however.
The key lock can be activated or deactivated by pressing the key
for more than 10 seconds. All yellow LEDs light up briefly to indi-
cate that the activation or deactivation is complete.

6.3 Settings mode

Pressing the key briefly switches between the status view and
the settings view.
If the key is pressed for between 2 and 10 seconds, the display
switches to settings mode if the operating panel keys are not
locked. As soon as the settings appear, they can be changed.
The settings appear in a specific order and can be run through in
a loop. Once the key is released, the display switches back to the
status display and the last setting is saved.
PERFORMANCE
SELECTED SETTING SELECTED SETTING
2 s.
UP 75-25(32)PK
This pump version can either be controlled externally via the
PWM profile A or run on a fixed characteristic curve according to
the selected speed.
One of four speed levels can be set.
 With external control, the pump runs at the speed specified
by the PWM signal.
 Without external control, the pump runs at the maximum
speed of the relevant speed level.
PWM profile A (heating)
PWM LED1 LED2
profile A Red Yellow
Level 1 ●
Level 2 ●
Level 3 ●
Level max. ●
EN-6
SETTING MENU
> 10 s.
> 2 s.
X
10 s.
LED3 LED4
Yellow Yellow
●
● ●
● ●
●
452115.66.53 · FD 9712
> 10 s.
Factory settings
During the first commissioning, the pump starts with the max.
characteristic curve
Changing the settings on the UP 75-25(32)PK
If the pump is switched on, it initially runs with the factory presets.
The current operating status is shown in the display.
1) Press the key to switch to the settings view. The LEDs indi-
cate the current setting for 2 seconds.
2) If the key is not actuated for more than 2 seconds, the dis-
play switches back to the "operating status" view, where the
current power consumption is shown.
3) If the key is pressed for longer than 2 seconds, the circulat-
ing pump switches to settings mode. The LEDs start to flash
and indicate the current setting. If the keyboard is locked, it
is not possible to switch to settings mode. In this case, the
keyboard must first be unlocked by pressing the key for
longer than 10 seconds.
4) The setting can then be changed within 10 seconds by
pressing the key. Each key activation switches to a different
control curve.
5) The process must be repeated until the desired setting is
achieved. If you miss the desired setting, the entire setting
process must be started again from the beginning, as it is
not possible to go back within the settings menu.
6) If the key is not pressed for longer than ten seconds, the dis-
play switches back to the status display. The last setting was
saved and the relevant control curve is applied.
7) It is advisable to check by pressing the key again so that the
display switches to the setting view and the LEDs indicate
the current setting for 2 seconds.
8) If the key is not pressed for longer than 2 seconds, the dis-
play switches back to the status view.
LED5
Yellow
●
●
UP 75-25PK - UP 75-32PK