Final Installation Checklist - Samsung DV339AE series User Manual

Gas and electric dryer

Hide thumbs Also See for DV339AE series:

User manual (72 pages)

Table Of Contents

Table of Contents

Available languages

installing your dryer

4-WIRE system connections

1. Remove the center terminal block screw.

2. Connect the ground wire (green or unwrapped) of the

power cord to the external ground conductor screw.

3. Connect the neutral wire (white or center wire) of the

power cord and the appliance ground wire (green with

yellow stripes) under the central screw of the terminal

block.

4. Connect the other wires to the outer terminal block

screws. Tighten the screws.

5. Tighten the strain relief screws.

6. Insert the tab of the terminal block cover into your dryer's rear panel slot.

Secure the cover with a hold-down screw.

1. External ground connector

2. Green or bare copper wire of power cord

3. 3/4 in. (1.9 cm) UL-listed strain relief

4. Center silver-colored terminal block screw

5. Grounding wire (green/yellow)

6. Neutral wire (white or center wire)

7. With a level, check your dryer and make necessary adjustments to the leveling legs.

8. At this time, make sure all gas connections (on gas models), exhaust and electrical connections are

complete. Plug in your dryer, and check operation by using the checklist below.

9. (GAS MODELS ONLY) - DV338AGW, DV338AGB

The burner may not ignite initially due to air in the gas line. Allowing your dryer to operate on a heat

setting will purge the line. If the gas does not ignite within 5 minutes, turn your dryer off and wait 5

minutes. Be sure the gas supply to your dryer has been turned on. In order to confirm gas ignition,

check the exhaust for heat.