Concrete And Tank Hole Alignment; Unpacking The Box; Recommended Parts; Recommended Tools - Tru-Test WaterPro 2 User Manual

Concrete and tank hole alignment

Check your measurements to ensure that the opening on the bottom of the tank aligns with the thermal earth tube
placement in the concrete. The opening on the bottom of the tank is off center. Ensure that the water supply lines
are not touching the sides of the thermal earth tube.
Underneath the WaterPro2

Unpacking the box

Recommended parts

In colder climates, we strongly recommend the use of one or more thermal earth tubes to help keep the vertical water
•
supply line from freezing. The thermal earth tube(s) must be long enough to extend 1 foot (305 mm) below the normal
frost line.
½ inch NPT male fitting to connect the vertical water supply line to the ½ inch flex line inside the tank. If your vertical
•
water supply line is more than ½ inch in diameter, you will also need an adapter.
250 W immersion heater for heating water in the tank (optional).
•

Recommended tools

Adjustable wrench
•
Pipe wrench
•
Measuring tape
•
Utility knife
•
Level
•
Hammer drill
•
½ inch masonry bit
•
Hammer
•
½ inch ratchet wrench
•
Caulk
•
5