Halsey Taylor OVL Owner's Manual
  1. Manuals
  2. Brands
  3. Halsey Taylor Manuals
  4. Water Dispenser
  5. OVL
  6. Owner's manual

Halsey Taylor OVL Owner's Manual

Fountains with bottle filler
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

OVL
™
HTHB-OVLEBP-I
INSTALLER
NOTE: It is common practice to ground electrical hardware such as telephones, computers and other devices
to available water lines. This can, however, cause electrical feedback in the plumbing circuit, which
results in an "electrolysis" effect occurring in the fountain. This may result in water which has a
metallic taste to it or has a noticeable increase in the metallic content of the water.
When inspecting plumbing circuit, remember the line may be grounded some distance from the
installation, and may occur outside the building or area in which the unit is being installed.
This condition can be avoided (in most cases) by using recommended materials during installation.
Any drain fittings provided by the installer should be made of plastic which will electronically isolate
the fountain from the remainder of the building's plumbing circuits.
OVLEBPWSI_NF
Fountains with Dual-Stream Bubbler
and HydroBoost
Review these instructions before beginning installation. Be sure that installation
conforms to all plumbing, electrical and other applicable codes.
When installation is complete, ensure these instructions are left in the plastic bag
provided inside the installed unit for future reference.
Service to be performed by authorized service personnel only.
OVLEBPWSI_WF
Owners Manual
Bottle Filler
®
HTHBWF-OVLEBP-I
Page 1
™
1000002449 (Rev. E - 04/18)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OVL and is the answer not in the manual?

Questions and answers

Related Manuals for Halsey Taylor OVL

Summary of Contents for Halsey Taylor OVL

  • Page 1 OVLEBPWSI_NF OVLEBPWSI_WF Owners Manual Fountains with Dual-Stream Bubbler ™ ™ and HydroBoost Bottle Filler ® HTHB-OVLEBP-I HTHBWF-OVLEBP-I INSTALLER Review these instructions before beginning installation. Be sure that installation conforms to all plumbing, electrical and other applicable codes. When installation is complete, ensure these instructions are left in the plastic bag provided inside the installed unit for future reference.
  • Page 2 OVLEBPWSI_NF OVLEBPWSI_WF Figure 1 - Rough-in Dimensions 1000002449 (Rev. E - 04/18) Page 2...

  • Page 3: Required Tools And Materials

    OVLEBPWSI_NF OVLEBPWSI_WF TO BUBBLER REQUIRED TOOLS AND MATERIALS These tables show special tools and/or additional materials (not provided) which are necessary to complete installation of these units: Special Tools Description Quantity Item NONE Additional Materials Not Included Quantity Item TO BOTTLE Description FILLER Unplated copper inlet pipe...
  • Page 4 OVLEBPWSI_NF OVLEBPWSI_WF 8. Install fountain with (4) 5/16-18 HHMS (provided) (Fig 5). Connect the ¼” water line from the fountain to the remaining opening on the tee (cut line to fit as needed). 33, 34, 35, 36, 37 9. Attach waste tubes (1-1/4” O.D.) to 1-1/4” O.D. slip trap. Trap on the bottle filler side must be 1-1/2”...

  • Page 5: Regulator Assembly

    OVLEBPWSI_NF OVLEBPWSI_WF Regulator Mounting Bracket Stream Height Adjustment Figure 7 Figure 9 Regulator Mounting Mechanism Regulator Assembly See Fig. 6 See Fig. 7 See Fig. 8 Figure 8 - Push Bar Mechanism See Fig. 9 3/8” Water Inlet Figure 10 - Drain Assembly WATERSENTRY PLUS FILTER PARTS LIST ®...
  • Page 6 OVLEBPWSI_NF OVLEBPWSI_WF BF11 - BF12 PROGRAM SETTING THE CONTROL BOARD VERIFY CONTROL BOARD SOFTWARE Continued from below: 1) To verify the software program of the control board the unit will 3) When display shows “UNIT TYPE” push program button once the need to be shut down and restarted.
  • Page 7 OVLEBPWSI_NF OVLEBPWSI_WF MAIN MOUNTING PANEL FRAME DRAIN LOCATION MOUNTING FRAME Figure 12 3/8” O.D. UNPLATED COP- 1/4” O.D. TUBE BUILDING WATER PER TUBE CONNECT WATER INLET INLET COLD WATER SUPPLY TO COOLER SERVICE STOP NOTE: WATER FLOW Note: Screw the locknut hand tight to seal (NOT FURNISHED) DIRECTION Figure 13 –...

  • Page 8: Installation Package

    OVLEBPWSI_NF OVLEBPWSI_WF PARTS LIST Installation Package ITEM PART NO. DESCRIPTION The components for installation are packed in 51546C Bubbler 27006C Basin two separate boxes, regardless of the type of unit 27000C Lower Shell being installed. The boxes contain the following: 27002C Fountain Arm (Long) 26988C Bottom Cover (Long) Box No. 1: Wall Frame(s) 55840C Top Plate Actuator...

This manual is also suitable for:

Dual-stream bubblerHydroboostHthb-ovlebp-iHthbwf-ovlebp-i

Table of Contents