Installing A Single Radio Module In Each Carrier - Lucent Technologies TransTalk 9000 Installation And Use Manual

Installing a Single Radio Module in Each Carrier

Remove the plastic cap covering each radio
1
module's card edge before inserting the radio
modules into the carriers.
Working from left to right, insert a radio module
2
into the first slot (Slot 1) of each carrier; hook
each radio module onto the mounting rod. Slowly
swing the radio module's card edge into the card
edge connector on the back of the carrier. (Excep-
tion: use Slot 6 instead of Slot 1 for a Model 117A3
control carrier.)
IMPORTANT:
Slot 6 of a Model 117A3 control carrier must
always contain a radio module to pass the
synchronization signal to the next carrier.
A Model 117A4 carrier does not require Slot 6
to be filled.
When the card edge is fully seated, a snap lock
3
on the bottom of the radio module will engage.
Insert a telephone line cord into the bottom of
4
each radio module.
Installing the MDW 9031 Pocketphone 2-33