Single Carrier Installation Self Test - Lucent Technologies TransTalk 9000 Installation And Use Manual

Single Carrier Installation Self Test

A single carrier must always function as a
1
control carrier. Wait a few seconds, then
compare the OUT OF SYNC and CONTROL/
EXPANSION LEDs against the top three lines on the
"SYNC and CONTROL/EXP LED Codes" label.
If the OUT OF SYNC LED is lit, power down,
2
wait at least 15 seconds, and then repower the
carrier. If the LED is still lit, follow the suggestions in
the "Installation Problems" section of Chapter 5,
"Troubleshooting." If the LED is still lit, call for help
as described on the inside cover of this book.
If you are using a Model 117A4 carrier, verify
3
that the carrier's CONTROL/EXPANSION LED
is lit and that its color is green. This is correct for a
single-carrier installation.
Verify the POWER and PASS LEDs on each
4
radio module are lit. If a radio module's PASS
LED does not light, power down the carrier and the
module, wait 15 seconds, and repower the module
and then the carrier. If the PASS LED still does not
light, refer to Chapter 5, "Troubleshooting."
NOTE:
The RADIO LED also may light upon installation;
however, since the RADIO LED has no significance
during installation, ignore its operation.
The RADIO LED indicates a connection between
the handset and the radio module; it lights
when the handset is being used as long as the
battery pack in the handset is charged.
2-28
Installing the MDW 9031 Pocketphone
Go to "Handset."