Panphonics AA-160 Operation Manual

Panphonics AA-160e / AA-160mm amplifier
Remote Control (for advanced users)
AA-160 series amplifier can be connected into the standard Local Area Network (LAN)
for controlling the parameters of the AA-160 series amplifier remotely. For handling
these features some networking experience is required. If you are connecting the
device into an already existing Network, please consult the Network administrator at
the first place.
The remote control from the Network makes it possible to adjust the volume or put
the amplifier into the standby mode or back into the operation. There are also a
great number of sophisticated commands for adjusting the Automatic Volume Control
–algorithm or chance the input sensitivity. The full command reference is at the end
of this manual.
Opening the Remote Connection
For TCP/IP control a telnet connection should be used. The default IP address of the
unit is 192.168.1.111. and network mask is '255.255.255.0' The default Telnet
password is 'passu'*. The device's IP address can be configured by using the following
commands.
*If Mac OS X terminal telnet client is used, the password might be asked twice because of the echoing defaults
ip
Print current IP settings
Usage: ip
Output: IP 192.168.1.111 / 255.255.255.0 GW=192.168.1.1
ip x.x.x.x
Change current IP address, use IP address 0.0.0.0 for DHCP. The new value does not take effect
until "ip update" command is sent. After "ip update" a new connection must be made and settings
saved by issuing "save setup". If the new settings are not saved after "ip update" the unit will
reboot after about 5 minutes and return back to the old settings.
Usage: ip 192.168.1.111
Output: OK
ip mask y.y.y.y
Change current subnet mask settings. The new value does not take effect until "ip update"
command is sent. After "ip update" a new connection must be made and settings saved by issuing
"save setup". If the new settings are not saved after "ip update" the unit will reboot after
about 5 minutes and return back to the old settings.
Usage: ip mask 255.255.255.0
Output: OK
ip gw z.z.z.z
Change current gateway settings. The new value does not take effect until "ip update" command is
sent. After "ip update" a new connection must be made and settings saved by issuing "save
setup". If the new settings are not saved after "ip update" the unit will reboot after about 5
minutes and return back to the old settings.
Usage: ip gw 192.168.1.1
Output: OK
Sound Shower AA-160e / AA-160mm Operation Manual v.2.0 26.3.2012 ©
Panphonics Oy 1/7