Chapter 2
Mounting Instructions
•
•
•
•
•
•
•
•
Pole Installation
To install the access point on a vertical or horizontal metal, wood, or fiberglass pole, you need the
following additional material and tools:
•
•
•
•
Cable Strand Installation
To install the access point on a cable strand, you need the following additional parts:
•
OL-12632-03
Optional fiber-optic 100BASE-BX10-U SFP, fiber-optic take-up reels, and liquid tight adapter
(GLC-FE-100BX-URGD=)
Optional outdoor-rated fiber-optic cable with 0.20 to 0.35 in. (0.51 to 0.89 cm) diameter
Optional shielded outdoor-rated Ethernet (CAT5e or better) cable with 0.20 to 0.35 in
(0.51 to 0.89 cm) diameter
Optional Ethernet RJ-45 connector and installation tool
Optional shielded outdoor-rated DC power cable with 0.20 to 0.35 in. (.0.51 to 0.89 cm) diameter
Optional cable Stinger connector
Optional ground rod, as required by local regulations
Optional ladder, power lift, rope, or other tools as required
Pole mount kit (AIR-ACCPMK1520=)
Pole clamp bracket
–
Two gusset strap brackets
–
One mounting bracket
–
Twelve hex bolts (M8 x16)
–
One M8 flange nut
–
–
Six M8 flat washers
–
Ten M8 split lock washers
–
Two stainless steel mounting straps
Customer banding strap tool (BAND IT)—(AIR-BAND-INST-TL=)
Customer supplied 13-mm and box-end wrench or socket set
Customer supplied adjustable wrench, 22 mm socket, or Sealcon S-2200-WR socket wrench
Cable strand mount kit (AIR-ACCSMK1520=)
Strand mounting bracket
–
Strand clamp bracket
–
Four cable clamps
–
Four M8 flange nuts
–
Four hex bolts (M8 x16)
–
Four M8 split lock washers and six M8 flat washers
–
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
Tools and Materials That You Supply
2-3