Cisco Aironet LAP1522 Hardware Installation Manual page 50

Mounting the Access Point
Step 4 Position the two bolts on the access point into the quick mount notches on each side of the mounting
bracket (see
Figure 2-8
Step 5 Screw a M8 x16 bolt (with flat and lock washers) into the second bolt hole on each side of the access
point.
Step 6 Ensure that the front of the access point is vertical, and tighten the four bolts to 13 to 15 ft lbs
(17.6 to 20.3 Nm).
Step 7 (Optional) When using the optional Cisco external omnidirectional antennas, connect them to the access
point as shown in
Note
Continue with the
Step 8
Point" section on page
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
2-20
Figure 2-8). Ensure that the hinged door is facing out.
Access Point Hanging in Mounting Bracket
Figure 2-2. Hand-tighten the antennas to the access point.
Some access point configurations might support two or three of the 2.4-GHz antennas.
"Grounding the Access Point" section on page 2-42
2-46.
Chapter 2 Mounting Instructions
and the "Powering the Access
OL-12632-03