Installation And Operation Manual For Demand Response (Dred) - Mitsubishi Electric PUMY-SP112 Installation Manual

9. Installation and operation manual for demand response (DRED)
This unit has demand response capability which is compliant with AS/NZS 4755.3.1: 2012.
To activate this function, you need to make a contract with remote agents such as electric supply company, then this unit should be connected to Demand response enabling
devise (DRED). For further information, consult your dealer. This unit supports 3 Demand Response Modes (DRMs): DRM1, DRM2 and DRM3.
■ Ask your dealer or technical representative to install the unit.
Any deficiency caused by your own installation may result in an
electric shock or fire.
■ Ensure that installation work is done correctly following this
instruction manual.
Any deficiency caused by installation may result in an electric shock
or fire.
■ Firmly connect the wiring using the specified cables.
Carefully check that the cables do not exert any forces on the
terminals.
Improper wiring connections may produce heat and possibly a fire.
■ Never try any modification.
Any deficiency caused by your modification or repair may result in
an electric shock or fire. Consult with your dealer about repair.
■ Wire so that it does not receive any tension.
Tension may cause wire breakage, heating or fire.
■ Use standard wires in compliance with the current capacity.
A failure to this may result in an electric leakage, heating or fire.
■ Do not wash with water.
Doing so may cause an electric shock or malfunction.
Remote Controller display
(PAR-33MAA)
Room
Cool Set temp. Auto
Mode Temp.
26
Fri
will appear on the Main display while the product is
operating in a demand response mode.
Fan
WARNING
■ All electrical work must be performed by a licensed technician,
according to local regulations and the instructions given in this
manual.
Any lack of electric circuit or any deficiency caused by installation
may result in an electric shock or fire.
■ Do not move and re-install this device yourself.
Any deficiency caused by installation may result in an electric
shock or fire. Ask your distributor or special vendor for moving and
installation.
■ Stop the operation if any malfunction occurs.
If malfunction occurs (burning smell, etc.) stop the operation
and turn off the power supply. Contact your dealer or technical
representative. If the controller continues to operate after a
malfunction occurs, this may cause damage, electric shock or fire.
■ Do not turn on the main power until installation has been
completed.
Doing so may result in electric shock or fire.
CAUTION
■ Do not connect the demand control transmission cable to the
terminal block for power supply.
■ Do not pull, extremely bend or apply strong pressure on the
wire to prevent failure.
■ Do not screw DRED to outdoor unit.
■ Do not put DRED in outdoor unit.
■ Secure electrical wiring above clamp.
■ Do not get DRED wire caught in the panel.
■ Secure the power supply cord, indoor/outdoor unit connecting
wire and DRED wire with the clamp and band.
The band is not used for the PUMY-SP•VKMD.