Advertisement
1. To prevent electric shock, do not operate the unit in standing water. Never plug in or unplug the
unit with wet hands or while standing in water.
2. To avoid risk of injury, do not direct air flow at face or body.
3. To reduce the risk of fire or electric shock, do not use the Mini Air Mover with any solid-state speed
control device.
4. Use only with GFCI protected receptacles. Please contact a qualified electrician for verification and /
or installation of a GFCI receptacle if necessary.
5. Do not operate the Mini Air Mover with a damaged cord or plug. Discard the unit or return it to an
authorized service facility for examination and/or repair.
6. Unplug the Mini Air Mover from the power supply before servicing or cleaning.
7. Do not run the power cord under carpeting. Do not cover the power cord with throw rugs, runners,
or similar coverings. Place the power cord away from traffic area to prevent tripping.
8. Do not allow children to play with or around the Mini Air Mover at any time.
9. Do not move or carry the Mini Air Mover while unit is operating.
10. Mini Air Movers in operation must be supervised at all times.
Model
Volt / Frequency
Power
Amp
Rated Airflow (On High)
RPM (Low / Medium / High)
Speeds
Built-In Power Outlet / Daisy Chain
3-Hour Timer
Positions
Unit / Box Weight
Unit / Box Size (L x W x H)
Power Cord (Length/Size)
Overheating Protection
Housing
Safety
Certificates
P-200T
115V / 60Hz
1/8 HP
1.5 Amps
600 CFM
1100 / 1250 / 1500
Three
No
Yes
4 (0°, 20° Kickstand, 45°, 90°)
8.5 Lbs. / 9.7 Lbs.
10.7"x12.4"x13.3" / 13.6"x12.8"x11" 10.7"x12.4"x13.3" / 13.6"x12.8"x11" 10.7"x12.4"x13.3" / 13.6"x12.8"x11"
10'/18AWG
Thermally Protected
Injection Mold / Polypropylene (PP)
ETL / C-ETL
P-200AT
115V / 60Hz
1/8 HP
1.5 Amps
600 CFM
1100 / 1250 / 1500
Three
Yes
Yes
4 (0°, 20° Kickstand, 45°, 90°)
8.7 Lbs. / 9.9 Lbs.
10'/14AWG
Thermally Protected
Injection Mold / Polypropylene (PP)
ETL / C-ETL
P-230AT
115V / 60Hz
1/5 HP
2.3 Amps
800 CFM
1000 / 1250 / 1500
Three
Yes
Yes
4 (0°, 20° Kickstand, 45°, 90°)
9.9 Lbs. / 11.1Lbs.
10'/14AWG
Thermally Protected
Injection Mold / Polypropylene (PP)
ETL / C-ETL
Advertisement
