Modifying The Address In Mpi Network Configuration - Siemens SIMATIC HMI OP3 Equipment Manual

Procedure
To set the modes, proceed as follows:
1. Choose the standard screen System
2. Set the mode you require by means of a symbolic input.
3. After you confirm your input by pressing ENTER, a warm restart is

10.4 Modifying the Address in MPI Network Configuration

Settings with
You can set and modify the address of the OP3 in the MPI network
standard screens
configuration by means of a standard screen. To do so, proceed as follows:
Procedure
1. Choose the standard screen System
2. Modify the OP address and, if necessary, the baud rate.
3. After you confirm your input by pressing ENTER, a warm restart is
Operator Panel OP3
Edition 11/99
performed.
performed.
System Settings on Standard Screens
Mode.
MPI Address.
10-3