Table of Contents
Advertisement
GSM module wiring harness
The included GSM module wiring harness
must be adjusted with corresponding
"pinning into" the existing installation
situation (heater selection). For this purpose,
the tied-back wires are stripped at the two
connection plugs in the direction of the
heater and heater control, then the required
wires are inserted according to the
illustrations on the cover pages and the wire
ends not required are tied back again
insulated..
Legend
On the illustrations on the cover pages.
br
brown
ge
yellow
gr
grey
rt
red
sw
black
vi
purple
---
not in use
Thermo Top E
Thermo Top C
Thermo Top Evo
SIM card
A SIM card not included in the delivery scope
is required to operate the unit.
Both 1.8 V and 3 V SIM cards of a network
operator, which supports the GSM 900/1800
mobile communications standard, can be
used.
Always observe any information of the
respective network operator when operating
the SIM card.
Before inserting the SIM card, the PIN code
must be changed to 1234 with a mobile
phone. Information on this topic is contained
in the respective operating instructions of
the mobile phone.
Thermo Call TC3
All data which may be present on the SIM
card will be deleted when commissioning the
GSM module.
The SIM card is inserted under the sliding
cover on the top of the GSM module with
the angled side opposite the hinge and with
the chip side facing downward.
Only insert or remove the SIM card in the
deenergised state.
The range is dependent on the respective
network operator. Costs result from the
operation of a SIM card. Information on this
topic and on roaming charges abroad and in
areas close to the border (due to network
overlapping) can be obtained from the
respective network operator.
7
Hide quick links:
Advertisement
Table of Contents
