Alarm System Operation; Alarm System Arming/Disarming; Alarm Condition; Alarm Cycle Limitation - LaserLine 270UK User Manual

ENGLISH
To arm the alarm, press the lock or deadlock** button on the vehicles original remote control; direction
indicators lights flash twice* and the alarm may give two acoustic tones* to indicate that the system is
now armed.
Once armed, the alarm system will operate the comfort closure**/window closure* if these functions
have been incorporated.
The red LED in the receptacle will remain on for 30 seconds (pre-alarm time), then begin to flash to
indicate the alarm system is fully armed.
To disarm the alarm, press the unlock button on the vehicle original remote control or insert a valid
electronic key into the receptacle socket; direction indicators lights will flash once* and the alarm may
give one acoustic tone* to indicate that the alarm system is now disarmed.
Ø at least 3 seconds should pass between locking/unlocking the vehicle, otherwise you may fail
to transmit the new arm/disarm status.
Ø it is possible to use the electronic key to disarm the alarm but not to arm it.
Ø comfort closure is a feature that may already be incorporated into the original remote control of
the vehicle. Check vehicle user guide for operation.
When fully armed if a sensor is activated, the system will generate an alarm condition: direction
indicators flash and the siren sounds for 30 seconds (alarm cycle). At the end of the alarm cycle, if the
same sensor is still activated, the alarm will generate an alarm cycle again.
The system will automatically exclude the sensor, which has generated 8 alarm cycles in one
armed period. All the other sensors will continue to protect the vehicle. The maximum number of
pag. 6
ISUT270-278UK.p65

4 - ALARM SYSTEM OPERATION

4.1 - ALARM SYSTEM ARMING/DISARMIG

4.2 - ALARM CONDITION

4.3 - ALARM CYCLE LIMITATION

6 12/05/2006, 10.24