My Fireplace Blower FAB-1600 Installation Instructions Manual

MY
FireplaceBlower
High Quality Aftermarket Fireplace Blowers & Fans
Instructions for Design Version - FAB-1600 Blower Kit
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE INSTALLING BLOWER!
When installed, make sure to contain any excess wire of the cord set;
Preventing it from making contact with moving or hot objects.
Drywall dust or other fragments may be present in your fireplace's vent space, clean this area before you install the
blower kit. Any bearing or motor damage resulting from this condition is not covered by the warranty policy.
This Blower Kit is tested and safe when installed in accordance with these installation instructions. It is your re-
sponsibility to read all instructions and consult the Owner's Installation Manual for your particular model number
for Supplemental Information before starting installation. Blower operates on 120V/60Hz power.

Blower Kit Parts

Check the contents of the carton.
Make sure nothing was damaged in shipment.
Do NOT install a damaged blower kit!
Description
Blower - Magnetic Mount
Thermodisc / Heat Sensor
Variable Speed Control
Cord Set
3-Prong to 2-Prong Adapter

Installation Instructions

Step 1: Turn Off Fireplace and allow it to cool
down. Disconnect from 120V Power. Shut off
the Gas supply. Remove the louver which cov-
ers the lower vent space below the firebox.
Lay cord set out in a straight line, with the
3-Prong Power Plug furthest away from the
fireplace.
Installer is responsible to check local codes
and read all instructions prior to installation.
Layout designed in U.S.A. © 2013
WARNING
RISK OF FIRE AND ELECTRICAL SHOCK!
Qty.
1
1
1
1
1
1
(Downloadable)
NOTE: Diagrams and Illustrations NOT to Scale
MyFireplaceBlower.com:
Step 2: Connect green wire from power cord to green
wire of motor; connect black and white wires of power
cord to either black wire attached to motor. Push dis-
connects together, one plastic insulator fits inside the
other.
Position blower with rectangle air exit ports facing up
and motor facing left. Slide blower into lower vent
space all center against the rear wall. (Figures: 1&3)
Figure: 1
Pull blower forward 1/8" to 1/4" from back wall of fire-
place. (Figure: 2)
Page 1 of 3
Installation Videos:
Installation Instructions:
1-800-466-4045
My Fireplace Blower
Burlington, Wisconsin
1-800-466-4045
CL ICK
CL ICK
CL ICK