Multi-code 1090 Installation Instructions

®
Installation Instructions
GARAGE DOOR RADIO CONTROLS
Model 3089 Transmitter
Model 1090 Receiver
WARNING:
• Disconnect power before any installation or repair
• Wear safety glasses
Your MULTI-CODE™ Radio Controls are designed specifically to remotely
control a garage door from within an automobile and to give years of dependable
service without adjustment. The transmitter/receiver combination utilizes the
MULTI-CODE™ scheme which permits the selection of as many as 1024 code
combinations of the ownerʼs personal choice. Because all radio controls are set
with the even numbered switches in the "ON" position when they leave the
factory, it is recommended that a different code be selected and set at the
time of installation. Please refer to the "Accessing the Code Switch" section for
instructions. The radio frequency (RF) portion of the controls, however, are
tuned to standard frequencies and are thoroughly tested at the factory. This
permits the addition or replacement of either the transmitter or the receiver by
s p e c i f y i n g t h e M o d e l N u m b e r a n d t h e R F f r e q u e n c y d e s i g n a t e d o n t h e
identification label. No RF adjustments are needed nor should any be attempted.
RECEIVER INSTALLATION
The receiver is designed to mount directly to the operator. It can be remotely
installed if the operator terminal strip is not accessible, or if power for the
receiver is not obtainable from the operator. To direct mount the receiver, simply
loosen the terminal screws on the operator and insert the two-way lugs from the
receiver under the screw heads along with the wall button wires), and tighten
the screws (See Fig #1).
Place the antenna (an 11 inch white wire) in a vertical position as far from any
metal as possible.
OPERA TOR TERMINA L
1
24 VOL T
2
REL A Y
3
COMMON
2 - WA Y L UGS
WA L L
B UTTON
For remote installation the receiver may be mounted near the operator head on a
joist or the ceiling by using the mounting tab. Order Model 1092-06 adapter,
which permits connection between the operator terminal and the two-way lugs
on the receiver.
OPERATOR
TERMINAL
STRIP
TO WA L L
PUSH B UTTON
Wh i t e
SWITCH
B l ac k
Red
!
Slip on connectors at one end of the adapter connect to the flat side of each
spade lug on the receiver, and spade connectors at the other end connect to
the operator terminal. Connect the wires as follows:
CODE SWITCH MA TCH
A NTENNA
Figure 1
Wh i t e
B l ac k
Red
Figure 2
MOUNTING TA B