Introduction - AEMC MiniFlex MF 300-6-2-10 User Manual

These safety warnings are provided to ensure the safety of person-
nel and proper operation of the instrument.
• Read this instruction manual completely and follow all the safety
information before attempting to use or service this instrument.
• Safety is the responsibility of the operator. The MiniFlex
be used only by qualified personnel using applicable safety
precautions.
• Wear protective clothing and gloves as required.
• Use caution on any circuit: potentially high voltages and currents
may be present and may pose a shock hazard.
• Read the safety specifications section prior to using the current
probe. Never exceed the maximum voltage ratings given.
• ALWAYS de-energize the circuit before wrapping the MiniFlex
around bare conductors, bus bars, or near live parts. Do not
wrap on live conductors.
• ALWAYS connect the electronic module to the display device
before wrapping the MiniFlex
• ALWAYS inspect the module, sensor, sensor cable, and output
terminals prior to use. Replace any defective parts immediately.
Use only factory parts.
• NEVER use the MiniFlex
1000V CAT III; 600V CAT IV.
2
Shop for Data Logging products online at:
CHAPTER 1

INTRODUCTION

WARNING
around the sample being tested.
®
on electrical conductors rated above
®
DataLoggerStore
www.
MiniFlex Flexible AC Current Probe
®
.ca
must
®
®
1.800.561.81