Table of Contents
Advertisement
5.1
Maintenance
Warning
•
For maintenance use only specified replacement parts.
•
To avoid electrical shock, do not attempt to perform any servicing
unless you are qualified to do so.
•
To avoid electrical shock and/or damage to the instrument, do not
get water or other foreign agents into the case.
•
Turn the instrument OFF and disconnect the unit from all the cir-
cuits before opening the case.
5.1.1
Battery Replacement
The battery must be replaced when the green indicator flashes or remains
off when the instrument is switched on.
•
Disconnect everything connected to the instrument and set the
switch to OFF.
•
Use a screwdriver to unscrew the two screws on the housing.
•
Replace the old battery with a new one (9V alkaline or lithium bat-
tery of type 6LF22).
•
Close the housing, making sure that it is completely and correctly
closed, then screw both screws back in.
5.1.2
Cleaning
•
It is important to keep the sensor latch mating surfaces clean to
prevent foreign matter from entering the closing.
•
The sensor may be gently cleaned with a soft cloth, soap and
water. Dry immediately after cleaning. Avoid water penetration
into the electronic module.
•
Make sure the sensor, electronic module, and all leads are com-
pletely dry before any further use.
MiniFlex
Flexible AC Current Probe
®
Shop for Data Logging products online at:
CHAPTER 5
MAINTENANCE
DataLoggerStore
www.
17
1.800.561.81
.ca
Advertisement
Table of Contents
