Advertisement
DO NOT inflate with an air compressor or other high
pressure pump!! This unit is designed to be inflated with a low
pressure inflator only.
Air valves – Remove the valve plugs from
each valve stem and insert the appropriate
attachment of your inflation device and inflate
until almost firm. Close valve by inserting the
valve plug into valve opening. Press firmly into
place until the plug is flush with the tube.
Repeat for remaining chambers.
DO NOT OVERINFLATE!!
Over inflating is a major cause of leaks or ruptures.
IMPORTANT: Notice the temperature of the air going into the
product and how it compares to the outside air. Heat causes air
to expand, while cold causes air to condense. If the inflator is
hot and sending warm air into the product, when the air cools, it
will seem like your product is losing air. This is normal. Let the
inflated product sit for a bit to acclimate to the surrounding
air/ground temperature, then re-inflate the tubes until firm.
Be aware of how air temperature may affect the inflatable
ice rink. The sun's heat will cause the air temperature to rise
and the air will again expand in the unit. If you are
experiencing a cold span you may want to add additional air,
but be careful that the unit does not become overinflated.
Snow may be packed under the side support tubes to create a
level rim for filling.
8
Advertisement
