Table of Contents
Advertisement
How to Use the Test Run Program
Check to see if the calculator is normal, using the procedure shown below.
Operation Procedure
1 . Depress the
key.
2.
Check to see if the (
f.'INAS)
key is not locked.
3.
Set the Test Run Program Tape in the cartridge reader while keeping the
labeled side of the cartridge upward.
4.
Depress the
key. When the MC R lamp is turned off and loading is
finished, take the cartridge tape out by pushing the EJECT knob forward.
5.
Depress the
key.
6.
Depress the [] key.
Remark: The Angle Form Slide Switch must be set at the DEG mode.
Indication and printing shown below should be obtained.
Indication:
Printing:
If the result shown above can't be obtained even when you carry out a correct
operation, inform the dealer or the service shop.
PUB. I E31 02E
1275BO.535
PRINTED IN JAPAN
:::::=.=:::-:-----=---:-:-:--=;:--=-=====----:-=:===-::--. .
- ~-.----
Advertisement
Table of Contents
