Belt Or Brushroll: Removal & Replacement - Dirt Devil M086020 Owner's Manual

FILTER REMOVAL & REPLACEMENT: CONTINUED
TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING: UNPLUG CLEANER BEFORE CHANGING FILTER.
NOTE: Filter should be cleaned as needed.
For Exhaust filter replacements, please visit our website at www.dirtdevil.com to buy online
or call customer service at 1-800-321-1134.
EXHAUST FILTER
Located on the side of the cleaner.
1.
Remove screw from filter
Pivot filter cage away
cage.
from body of cleaner then
remove.
4.
5.
Tap the filter on the inside Return HEPA filter cartridge
of a garbage can to remove to cleaner.
excess dust and dirt. DO
NOT APPLY WATER TO
PLEATED FILTER!
3.
2.
Grasp HEPA filter cartridge
and remove.
6.
Return filter cage to
cleaner by inserting tabs
on corners of filter cage
into slots on side of the
cleaner. Rotate back into
place and secure with the
one screw.
9
BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
BELT STYLE
5
For Belt Style 5 replacements, please visit our website at www.dirtdevil.com to buy
online or call customer service at 1-800-321-1134.
TO REMOVE OLD BELT
2.
1.
Lay cleaner flat and flip cleaner to expose Rotate/pivot the nozzle guard
nozzle base. Base should lay flat and and pull off.
face up. To remove nozzle guard, use
Phillips screwdriver to remove the four (4)
screws. Arrows show location of screws.
TO REPLACE NEW BELT
1.
Slide belt onto
motorshaft. Place
new belt in area
of brushroll without
Motor
Shaft
bristles (see inset).
3.
Secure by aligning
the three (3) tabs
in the base slots.
To reattach nozzle
guard, rotate/pivot
back into position.
3.
Lift and remove brushroll.
Dispose of old belt.
2.
With new belt in place,
pull and slide brushroll
into nozzle making sure
that the brushroll end
caps are in the correct
orientation (see inset).
Rotate brushroll manually
to make sure belt is
properly aligned.
4.
Replace all four (4)
screws to secure nozzle
guard. NOTE: Make sure
bumper is secure before
replacing screws.
10