Table of Contents
Advertisement
Utilizzo connessione remota / MD Uscita / D&N Ingresso
Connettendo una spina alla presa REMOTE posta nella parte posteriore della camera, e'
possibile accedere al menu impostazioni, da postazione remota.
1. Impostazione della Comunicazione RS-232C.
• Modalita': Seriale
• Bit Dati : 8
• Bit di Stop : 2
• Porta: Com1
• Controllo Flusso : XON / XOFF
2. Comandi Menu Impostazioni
Impostazione menu
Comando
Set-Imposta
Up-SU
Down-GIU'
Right-Destra
Right-Destra
3. Livello del segnale d'uscita MD(Motion Detection)(inferiore a10mA)
0V
Senza Movimento
5 ± 0.5sec
4. Ingresso del segnale di controllo D&N : Volendo utilizzare la modalita' EXT, accertarsi
che il sistema soddisfi le condizioni riportate di seguito.
• Per modalita' DAY/Giorno, il terminale D&N dovrebbe essere scollegato da GND.
• Per modalita' B/W, il terminale D&N dovrebbe essere collegato a terminale GND.
Note
• Quando si collega o si rimuove la spina per remoto, spegnere l'alimentazione della telecamera.
38
COLOR CCD CAMERA
• Bit/sec : 9600bps
• Parita' : Nessuna
Byte
153
1
65
1
66
1
67
1
68
1
+4.0V ~ +5.0V
Con Movimento
Manuale Utente
Problemi e soluzioni
If you have trouble operating your camera, refer to the following table. If the guidelines do
not enable you to solve the problem, contact an authorized technician.
Problem
Nothing appears on the
• Check that the power cord and line connection
screen.
between the camera and monitor are fixed properly.
• Check that you have properly connected VIDEO cable to
the camera VIDEO output jack.
• Check that the DC/VIDEO selection switch on the side of
the camera is set to a proper position according to the
type of your auto iris lens.
• Are you using Auto Iris Lens with VIDEO type?
Adjust VR Level properly (refer to page 31)
• Is lens stained with dirt? Clean your lens with soft,
The image on the screen
clean cloth.
is dim.
• Set the monitor to proper condition.
• If the camera is exposed to too strong light, change the
camera position.
• Adjust the lens' focus properly.
The image on the screen
• Adjust the contrast feature of the monitor.
is dark.
• If you have an intermediate device, set the 75Ω / Hi-z
properly. (refer to page 19)
• Are you using the Auto Iris Lens? Adjust the level
on the lens properly.
• Check that you have properly connected the camera to
The camera is not
working properly, and
an appropriate power source. (refer to page 20)
the surface of the
camera is hot.
COLOR CCD CAMERA
Solution
39
Manuale Utente
Advertisement
Table of Contents
