McConnel ROBOPOWER Operator's Manual page 43

The following plates are on the receiver unit:
tion plate
Rating plate
The remote control unit feature four LEDs:
• RUN green
• ERR red
• POWER green
• ALARM red
The RUN LED indicates the status of the remote control's communication status with the CAN
network Master node.
Off
Flashing
Access
The ERR LED indicates the status of the CAN communication.
Off
Flashing
Access
- This is found on the casing of
the receiver unit on the con-
nectors side:
This is found on the left-hand
side of the casing.
The remote control unit as a node in the CAN network is off.
The remote control unit is not sending commands to the CAN network.
The remote control unit as a node in the CAN network is working properly.
The CAN communication is working properly.
The CAN communication is not working properly.
No CAN communication.
30
The serial number of the
remote control, a bar code and
the year of manufacturer.
The MODEL, TYPE and main
technical data of the receiver,
the markings and any remote
control trademarks.