McConnel ROBOPOWER Operator's Manual page 120

1. Loosen the bleed screws (A).
2. Unlock the bayonet lock (B) of the fuel delivery
pump by pressing and simultaneously turning
anticlockwise. The pump piston is now pushed out
by the spring.
3. Pump until no more air comes out of the bleed
screw.
4. Tighten the bleed screw completely. Tightening
torque 6.5 +/- 1.3 Nm
5. Lock the bayonet lock of the fuel delivery pump by
pressing and simultaneously turning clockwise.
6. Start the engine for about 5 minutes at idle or at a
DANGER:
CAUTION:
To clean (daily) and replace (at 1000 hours
• Remove the rear left-hand panel with the key for the purpose;
•
•
movements and at the same time pull the cartridge, clean it with a jet of air or replace it as
needed.
- Bleeding the fuel distribution system
107