Miele KM 6328-1 Operating And Installation Instructions page 43

Problem solving guide
Problem
The  symbol appears
in one or more cooking
zone displays and the
hob switches off auto-
matically.
A cooking zone
switches off automatic-
ally.
A cooking zone
switches off automatic-
ally.
The Booster has deac-
tivated early automatic-
ally.
The cooking zone is not
working in the usual
way on the power set-
ting selected.
Power level 9 is auto-
matically reduced if you
select power level 9 on
two linked cooking
zones at the same time.
The food in the pan
does not heat up when
the Auto heat-up func-
tion is switched on.
An operating noise can
be heard after the appli-
ance has been switched
off.
 and numbers are
flashing in the cooking
zone displays and a
tone sounds.
42
Cause and remedy
One or more of the sensors are covered, e.g. by finger
contact, food boiling over or an object.
 Clean off any dirt or remove the object (see
"Safety switch-off").
It has been operated for too long.
 You can use the cooking zone again by switching
it back on (see "Safety switch-off").
The overheating protection mechanism has been ac-
tivated.
 See "Overheating protection".
The overheating protection mechanism has been ac-
tivated.
 See "Overheating protection".
The overheating protection mechanism has been ac-
tivated.
 See "Overheating protection".
Operating both zones at power level 9 would exceed
the permitted maximum power for the two zones.
 Use a different cooking zone.
A large amount of food is being heated up.
 Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a different pot or pan which conducts heat
properly.
The cooling fan runs until the hob has cooled down
and then switches off automatically.
The hob is incorrectly connected.
 Contact Miele. The hob must be connected to the
mains according to the wiring diagram.
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.