Detailed Programming Guide; User Settings - CAMDEN CV-110SPK Installation Instructions Manual

8. To Reset to Factory Default
a. Disconnect power from the unit
b. Press and hold # key while powering the unit back up
c. On hearing two "Beeps" release # key, system is now
back factory settings
9. Anti-Tamper Alarm
The unit uses a LDR (light dependent resistor) as an
anti-tamper alarm. If the keypad is removed from the cover,
the tamper alarm will operate.
10. Sound and Light indication
Operation Status
Power on
Stand by
Press keypad
Operation successful
Operation failed
Enter into programming mode
In the programming mode
Exit from the programming mode
Open the door
Alarm

11. Detailed Programming Guide

11.1 User Settings

To enter the programming mode
To exit from the programming mode
Note: You must be in programming mode to perform any of the following functions
To change the master code
Setting the working mode:
Set valid card only users
Set valid card and PIN users
Set valid card or PIN users
Standalone Keypad/Prox Access Control
Note: Only the installer data is restored, user
data will not be affected.
Red Light Green Light
-
Bright
Bright -
- -
- Bright
- -
Bright -
- -
Bright -
- Bright
Bright -
* Master code #
999999 is the default factory master code
*
0 New code
The master code can be 6 to 8 digits long
3 0
3 1
3 2
Page 4 of 8
Yellow Light
-
-
-
-
-
-
Bright
-
-
-
# New code #
# Entry is by card only
# Entry is by card and PIN together
# Entry either by card or PIN (default)
Buzzer
Beep
-
Beep
Beep
Beep/Beep/Beep
-
Beep
Beep
Beep
Alarm