Advertisement
Step By Step Guide
1. Remove the light unit from the plastic wrapping.
2. Slide the protective cover out from the unit and remove the
protective fi lm from both sides of it.
3. Slide the protective cover back into the light unit.
4. Plug the light unit in and turn the switch "on" to ensure the
light works.
5. Place the light unit on top of the aquarium. Make sure it
is positioned so that it will not get wet nor will it fall into the
aquarium.
Changing The Tubes
Refer to diagram on page 3 for parts identifi cation.
1. Ensure your hands are dry. Turn off the light and remove the
plug from the receptacle.
2. Remove the light from the aquarium.
3. Slide the protective cover out.
4. With both hands, turn the tube either clockwise or anti
clockwise to remove.
5. Insert the new tube into the tombstones and again, turn
either clockwise to lock the tube in place.
6. Plug the light back into the receptacle and turn it on to
ensure it works before mounting it back on the aquarium.
Changing The Starter
1. Ensure your hands are dry. Turn off the light and remove the
plug from the receptacle.
2. Remove the light from the aquarium.
3. Remove the 2 screws from the endcap labelled "starter
end".
4. Remove the endcap.
5. turn the starter anti clockwise to secure in place.
6. Insert a new starter and turn it clockwise to secure in
place.
7. Place the endcap onto the light unit and secure using the
2 screws.
8. Plug the light unit back into the receptacle and turn it on to
ensure it works before mounting it back on the aquarium.
Trouble Shooting
Light does not work:
1. Ensure the plug is inserted correctly and the switch is in
the "on" position.
2. The starter or fl uorescent tube may require replacing.
NOTES
4
Advertisement
