Advertisement
Installation Instructions
Models
Tools Needed
Stud Finder (Optional)
Carpenter's Level
Tape Measure
Utility Knife
Phillips Screwdriver
Small Flat Head Screwdriver
1/4" Nut Driver (Optional)
Drill (Electric Recommended)
1/8" Drill Bit
1/4" Drill Bit (Surface Mount)
Safety Glasses
A-46
A-42
E-342
NE-342
NE-242
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Iron-A-Way A-46
Summary of Contents for Iron-A-Way A-46
- Page 1 Installation Instructions Models A-46 A-42 E-342 NE-342 NE-242 Surface Mounting Instructions Electrical Instructions Tools Needed Stud Finder (Optional) Carpenter's Level Tape Measure Utility Knife Phillips Screwdriver Small Flat Head Screwdriver 1/4" Nut Driver (Optional) Drill (Electric Recommended) 1/8" Drill Bit 1/4"...
- Page 2 3. Locate the existing wiring or other utilities in the wall to prevent drilling into or severing a wire or other utility during installation. 4. Determine the desired location has adequate clearance for ironing. Door opens approximately 180°. Allow at least 16" from side of cabinet for door to swing open. A-42 A-46 with E-342 E-342 with Optional Swivel NE-242 with...
- Page 3 7. Connect all power supply wires and ground wires in accordance with all electrical codes. Trim as necessary excess supply wire. Note for Models A-46 and AL-42: Inside the front cover of the electrical wireway there is a yellow label that identifies the Electrical Supply Connection Area. Make certain that when wiring the ironing center, the wire nuts are placed and secured into the area identified by the yellow tag.
Need help?
Do you have a question about the A-46 and is the answer not in the manual?
Questions and answers