AUTEC E16STXUS1 Manual

1

Description

A
B
2

Programming

The transmitting module E16STXUS1 has two groups of DIP switches: a group of 4 and a
group of 8 DIPs. They program some functions and set the working frequency.
The Autec programming set in the other group of four dip switches must never be modified.
The group of eight dip switches located on the radio module are used to program some func-
tions and set the working frequency.
DIP STATE
ON
1
OFF
ON
2
OFF
ON
3
OFF
3-7 ON/OFF If DIP 8 is ON see "Frequency Table"
ON
8
OFF
E16STXUS1 guide
D
C
The transmitting unit never switches off automatically
If the transmitting unit stays switched on without any movement
commands entered, it switches off after approx. 3.5 minutes
Deactivation of low battery warning from horn on machine
Activation of low battery warning from horn on machine
If DIP 8 is OFF automatic scan of the frequencies in the band 915 -
928 MHz
If DIP 8 is OFF automatic scan of the frequencies in the band 902 -
915 MHz
Manual selection mode of the frequencies using DIP 3 - DIP 7 (refer to
"Appendix: Frequency Table")
Automatic scan mode of the frequencies in the band selected by DIP 3
(DIP 4 - DIP 7 indifferent)
connector for interface card or
A
keyboard
B address key
C DIP switches
D antenna
FUNCTION
E16STXUS1 guide
1