Honda 2018 Jazz Manual page 494

uuIf a Tyre Goes FlatuChanging a Flat Tyre
■
Replacing the Flat Tyre
492
1. Remove the wheel nuts and flat tyre.
Wheel Nut
2. Wipe the mounting surfaces of the wheel
with a clean cloth.
3. Mount the spare tyre.
4. Screw the wheel nuts until they touch the
lips around the mounting holes, then stop
rotating.
5. Lower the vehicle and remove the jack.
Tighten the wheel nuts in the order
indicated in the image. Go around,
tightening the nuts, two to three times in
this order.
Wheel nut torque:
108 N∙m (11 kgf∙m, 80 lbf∙ft)
1Replacing the Flat Tyre
Do not over tighten the wheel nuts by applying extra
torque using your foot or a pipe.
Models with wheel cover
Make sure the wire support ring is hooked into the
clips around the edge of the wheel cover.
Clips
Align the valve mark on the wheel cover to the tyre
valve on the wheel, then install the wheel cover.
Valve Mark
Clips