Adjusting The Lcd During Play; Controlling Sound From The Speaker - Samsung SCD 5000 User Manual

ENGLISH
Preparation

Adjusting the LCD during PLAY

You can adjust the LCD during playback.
The adjustment method is the same as is used while in CAMERA mode. (See page 32)

Controlling Sound from the Speaker

The Speaker only works in PLAYER mode.
When you use the LCD screen for playback, you can hear the recorded sound from
the built-in Speaker.
- Follow the instructions below to decrease or mute speaker volume in PLAYER mode.
- Take the following steps to lower the volume or mute the sound while playing a tape
on the camcorder.
1. Set the device to CAMCORDER and set the Power Switch to PLAYER mode.
2. Press (PLAY/STILL) to play the tape.
3. Once the tape is in play and you hear sound, use the MENU DIAL to adjust the volume.
A Volume Level display will appear on the LCD.
Levels may be adjusted from anywhere between 0 to 19. You will not hear
any sound when the volume is set on 0.
If you close the LCD while playing, you will not hear sound from the speaker.
Notes
When the cable is connected to the A/V jack, you cannot hear sound from the speaker and
cannot adjust the volume.
You can hear sound from the speaker by removing the connected cable from the A/V jack
34 34
FADE
S.SHOW
BLC
REV FWD
<3-2>
0 : 2 3 : 4 7
5 5 min
VOL. [ 1 1 ] 1 2 : 0 0 AM
O C T . 1 0 . 2 0 0 3