Read Before Using Key/Tracking Key Pro - LandAirSea Tracking Key User Manual

LandAirSea Tracking Key/Pro ® User Guide
Read before using Key/Tracking Key Pro
KNOW HOW GPS WORKS. The Tracking Key/Tracking Key Pro uses GPS to find its location.
In order to lock onto the location, the GPS unit must have a direct line of sight to 3 locations in the
sky and these locations are changing constantly throughout the day. Make sure that there isn't
any metal completely blocking this upward / outward line of sight. GPS signals will go through
plastic, glass, rubber, fiberglass, cloth material, or anything else not made of metal. The more
metal obstructions that are above and around the GPS sensor the longer it will take to lock onto
the location. Make sure you choose a good location to place the unit or antenna for good results.
An example of placement for the Tracking Key is the glove box but depending on the design of
the vehicle, it may take longer to lock onto the location. If the glove box is very low inside the
vehicle with a lot of obstructions, it may not be able to track. In this case you will have to find a
better location to place the GPS unit.
TAKE A TEST DRIVE (VERY IMPORTANT). Take the unit for a test run with the GPS unit on
your dashboard for at least a few miles. Make sure to wait for the GPS light to start flashing (this
will take 1 to 2 minutes after replacing batteries). This is an indication that the unit is working
properly. After 2 minutes of inactivity, the unit will go into a very low power mode which will not
drain the batteries. Now download your test data by following the Quick Start Guide for
Downloading Data.
Please Note: Do not put additional stress on the magnet mount by pulling straight from a metal
surface. You should gently tilt the unit by pulling away from the metal near the USB cap which will
easily release the magnet from the metal contact. Removing the unit this way will avoid damage.
Location
On the front or rear dash
board
Under the front or rear
dash board
In the glove box
Under or on the seat or
under vehicle
Unit Placement
Effectiveness
99%
95%
80-95%
85%
®
Comment
Probably one of the best locations to keep your
unit if you do not need to conceal the device.
You can place the unit in a box of tissues or in
something on the dash.
It is important to remember that the unit must be
high enough up in the dash board to make an
effective lock. Spotty data will indicate that your
placement may need to be adjusted.
This is good location to keep your unit.
Effectiveness may vary from one vehicle to
another, but if placed properly it should work in
the glove box of almost any vehicle.
Placement under the seat of vehicle will vary
from vehicle to vehicle. If you must place the
unit under the seat or the vehicle, make sure you
test it for a day or two to make sure it will work in
your vehicle in the location you have chosen.
LandAirSea, Inc | User Guide 2010 15