Stove Cleaning - Accont SAHARA Type I. Operation Manual And Warranty

to black shade. It shall be necessary to replace the entire sealing for the new one (the sealing
tapes) on the place of discolouration, or to restore the sealing using cement, where the cement
is used. During the stove operation, when you heat in it, keep the proximity of the stove in clean
condition, check the exterior part of the stove, in particular take care the loading door (Fig. 1 -
position a) and the ash-can door (Fig. 1 - position b) are duly closed, the regulation controls
must be in the correct position (Fig. 1 - position d), e), the fume duct must be safely connected
since the leakage of fume products of combustion to the stove surroundings is not allowed.
When smelling a suspicious smell, provide for the adequate venting and stop burning fuel in the
stove till the cause is remedied. We recommend you to procure and get assembled the relevant
detectors (CO2, CO, fume, temperature) in the surrounding area of the stove warning you in
case of possible leakages of dangerous gases, fume and of the risk of fire. Check the course of
burning process. The burning should be calm, silent, even, the flame in the stove should be of
light orange colour, and the fume coming out of the chimney should be pale. You shall thus
avoid:

killing of humans and animals by suffocation, CO2 and fume,

killing of humans and animals by poisonous gas CO that cannot be smelled, it is also
invisible!!!

killing of humans and animals by fire,

damages of property,

damages of the surrounding,

traumas of the affected persons and their relatives.
Through the inspection opening (Fig. 1 - position f) check in particular the amount of
deposited solid particles and carbon particles as well as the internal space, where the fume duct
is connected to the stove. The solid non-burnable particles from the combustion products
leaving the stove via fume duct to the chimney (dust) and carbon particles are partially
entrapped in the contaminant indicator. If full of contaminants from combustion products,
simply clean it following the chapter on stove cleaning, place it to the original place and cover
the inspection opening (Fig. 1 - position f). Caution, the contacting areas must be freed from all
contaminants so that they are duly tight (even without a sealing).

STOVE CLEANING

The inspection opening should be open only when the stove is out of
operation, after the hot coal is removed and the stove must be
entirely cold! It serves for the primary informative visual inspection of
the interior part of the stove.
-18-