Installation And Connection To A Chimney - Accont SAHARA Type I. Operation Manual And Warranty

INSTALLATION AND CONNECTION TO A CHIMNEY

The cast-iron stove is designed in such a way it would be possible to connect it to a
suitable chimney using fume tubes, elbow bends and other connecting elements. When
assembling and operating the stove, it is necessary to observe all the local regulations, national
and European standards in force. It is also unconditionally necessary to follow the fire safety
regulations. The stove may be installed in any usual space in accordance with STN 33 0300.
Find a place where the stove shall be installed. Check for the rigidity of the structure
under the stove so that it would safely carry the weight of the stove in vertical position. As long
as the rigidity of the structure under the stove is insufficient, it shall be necessary to adopt the
measures that would sufficiently reinforce the floor under the stove (e.g. the use of solid, heat-
resistant insulation pads that would distribute the load). When assembling, operating and
placing the stove on the selected place, all the local regulations, including those ones regarding
the national and European standards must be mandatory followed. Always ensure the supply of
a sufficient amount of combustion air on the place where the stove is located, in particular in
the rooms where exhausting device, air conditioning and tightly closable windows and doors are
located.
Warranty applies to the stove only if it was installed, assembled and put
into operation by the authorised serviceman, which is proved by the
drawn and acknowledged protocol kept by the relevant authorised
servicing organisation.
The stove assembly shall only be carried out by the serviceman trained
by the stove manufacturer. The stove assembly should be carried out
minimally by two adult persons since it is required by the weight of the
stove.
Air exhausters working in the same room or space as the appliance may
cause problems!
-8-