Cast-Iron Stove Operation; Fuel; The Oven Operation At Nominal Power And Heating-Up - Accont SAHARA Type I. Operation Manual And Warranty

CAST-IRON STOVE OPERATION

The stove is delivered already burned out at the temperature of 260 °C for 40 minutes,
in the disassembled condition. After the stove assembly, after 24 hours of cement hardening
and connection to the chimney, it shall be necessary to slightly make a fire in them so that the
individual parts could find their place (the thermal running-in as a whole) i.e. the running-in
heating. It is necessary to burn very little amount of wood for ca 30 minutes (first heating) in the
stove. Then let the stove slowly cool down.

FUEL

The stove was designed for the combustion of wooden split and whole logs of a
reasonable circumference up to ca 28 cm (dried for two years) so that the wood could freely
pass the loading hole to the furnace. The recommended lengths of loaded wood: approximately
from 15 to 40 cm, according to the stove type.

THE OVEN OPERATION AT NOMINAL POWER AND HEATING-UP

1. Turn the supply of primary inlet combustion air (Fig. 1 - position d) to MAX position
according to the pictogram on the stove (Fig. 2 - position a). The lever position
should be used mainly when making a fire.
2. Open the supply of secondary inlet combustion air to maximum (Fig. 1 - position e) in
the similar way to MAX position according to the pictogram on the stove (Fig. 2 -
position b).
Only adult and competent person may operate the stove!
When operating the stove, always use the heat resistant gloves supplied
with the stove.
-12-