Apantac HDMI-1-E User Manual

HDMI-1-E FRONT VIEW
1. HDMI Input from the Source
HDMI-1-E REAR VIEW
1. Link Activity Status (Green)
2. Local Power Status (Amber)
3. RJ45 for CATx Output to Receiver
4. 5V 1A Power
HDMI-1-R FRONT VIEW
1. Cable Equalization Adjustment
2. HDMI Output to the Monitor
HDMI-1-R REAR VIEW
1. Link Activity Status (Green)
2. Local Power Status (Amber)
3. RJ45 for CATx Output to Receiver
4. 5V 1A Power
Troubleshooting Q & A
There is no image on my monitor.
This may be an EDID issue. Follow the
EDID learning procedure described in this
manual.
There is no image on my monitor.
Check the following:
Cable length.
Cable quality. (Low skew FTP cables
perform better than regular network
cables.)
Adjust the EQ knob slowly until the im-
age appears.
The output of display has noise or oc-
casionally flashes.
Check the cable distance.
Slowly adjust the EQ knob until the im-
age appears. It is best to use a pattern
generator instead of the source to per-
form this adjustment.
Check for excessive RF interference in
the room.
© 2012 APANTAC LLC, All Rights Reserved
7556 SW BRIDGEPORT ROAD
PORTLAND, OR 97224, USA
PHONE +1 503 968 3000
FAX +1 503 389 7921
The content of this document is provided in connection with
Apantac LLC ("Apantac") products. Apantac makes no
representation or warranties with respect to the accuracy or
completeness of the contents of this publication and re-
serves the right to make changes to specifications and prod-
uct descriptions at any time without notice.
HDMI-1-E
HDMI-1-R
USER MANUAL
HDMI CATx
Extender / Receiver