Page 1
Smart Control Kit Installation Guide Installation requires no special tools—you’ll just need a screwdriver, stepladder and smartphone! Item No: V2 adhguardianusa.com 1-424-272-6998...
Thank you for purchasing the beam Smart Control Kit! Please read and follow all installation instructions. These instructions include your secure Blackbox Code. Homeowners should retain this guide for reference. _____________________ Date Installed: Register your Smart Control Kit online at: adhguardianusa.com/warranty-information Warning: To reduce the risk of injury to persons:...
Page 3
Unbox the contents of your kit Your kit should contain two AAA batteries and the following: Blackbox controller Power adapter Wireless door sensor Opener cable...
Page 4
Mount the Blackbox controller • Locate the Blackbox and grab your stepladder. • Clean and wipe dry your selected mounting location, either on the garage door opener or a nearby surface. Mount using the adhesive strips on the back of the Blackbox. TIP: The Blackbox should be mounted within 6 feet of the garage door opener and a power source.
Page 5
Connect the opener cable to the Blackbox controller • Locate the opener cable • Plug the black connector into the Blackbox “OPENER” port. OPENER DC IN STATUS...
Page 6
Connect the Blackbox controller to the garage door opener • Unplug your garage door opener. • Using your screwdriver, connect the other end of the opener cable to your garage door opener push button terminals. TIP: View sample connection diagrams for other garage door opener makes and models at: adhguardianusa.com/beam PUSH BUTTON...
Page 7
Power up the Blackbox controller • Locate the power adapter and plug into the DC IN port on the Blackbox • Plug the other end of the power adapter into the closest power source. The status LED on the side of the Blackbox should begin to blink orange for setup.
Page 8
Connect to WiFi • Download the beam app from the App Store (iOS) or Google Play (Android). • Open the app and select “Setup Your Smart Control Kit.” • Follow prompts within the app to select your wireless network and enter your network password. TIP: If you are a professional installer, setup in the beam app should be done using the homeowner’s smartphone.
Page 9
Program the Blackbox controller • Follow prompts within the app to program the Blackbox • When directed, press your phone screen tightly against the bottom setup port. TIP: If setup is successful, the Blackbox’s status LED will flash green and there will be an audible beep. If setup is not successful, you will be guided through setup again.
Page 10
Scan the wireless door sensor code • Locate the wireless door sensor • Follow prompts within the app to create an account and scan the Sensor Code found on the back of the sensor. • Enter a name to identify that door within the app.
Page 11
Mount the wireless door sensor • Clean and wipe dry an area at the top of your garage door’s interior panel. • Remove the battery tab from the back of the wireless door sensor and mount to the cleaned area of the garage door using the adhesive Velcro strips.