Air Controls; Using Burn Rate Air Control & Acc System - Quadra-Fire 21M-ACC-AU Owner's Manual

3. Final Stage
The final stage of burning is the charcoal stage. This
occurs when the flammable gases have been mostly
burned and only charcoal remains. This is a naturally
clean portion of the burn. The coals burn with hot blue
flames.
It is very important to reload your appliance while
enough lively hot coals remain in order to provide the
amount of heat needed to dry and rekindle the next
load of wood. It is best to open the Burn Rate Air and
Start-Up Air Controls before reloading. This livens
up the coal bed and reduces excessive emissions
(opacity/smoke). Open door slowly so that ash or
smoke does not exit appliance through opening. You
should also break up any large chunks and distribute
the coals so that the new wood is laid on hot coals.
Air quality is important to all of us, and if we choose
to use wood to heat our homes we should do so
responsibly. To do this we need to learn to burn our
appliances in the cleanest way possible. Doing this
will allow us to continue using our wood appliances for
many years to come.
D. Air Controls
Users will need to find their preferred setting between
high and low based on desired heat output, installation
configuration, and fuel type.
1. Burn Rate Air Control
This air supply enters at the upper front of the firebox,
near the top of the glass door. This preheated air
supplies the necessary fresh oxygen to mix with the
unburned gases, helping to create second, third and
fourth combustions. This air is regulated by the Burn
Rate Air Control. When the control is moved all the way
up it is on the High setting and when moved all the way
down it is on the Low setting (Figure 9.1).
2. Automatic Combustion Control System (ACC)
To engage the Automatic Combustion Control (ACC)
timer system push the lever towards the back of the
appliance to the "HI" position, then pull forwards
towards the front of the appliance until the knob stops.
The timer will slowly close in about 25 minutes. Use
this feature when reloading fuel or if you want more air
supplied to the fire (Figure 9.3).
E. Using Burn Rate Air Control & ACC System
1. Start up and Reloading Fuel
Open both Burn Rate Air Control and ACC systems
fully. To do this with the Burn Rate Air Controls push
spring handle up to high. For the ACC timer system
push knob towards back of appliance until the knob is
located under the high position (Figure 9.1).
2. Maximize Heat with The ACC System
To maximize heat output with the ACC timer System
or also known as high burn push the ACC Air Control
lever towards the back of the appliance and leave. This
combined with having the main burn rate control lever
pushed up will deliver the most amount of air needed to
achieve the highest amount of heat output (Figure 9.1).
16 August, 2018
3. Manual Timer Over-Ride
If you need to shut the ACC system off before it goes
through the cycle of shutting itself off; 25 minutes,
reach towards the back of the appliance on the
right side and pull the lever towards the front of the
appliance (Figure 9.2).
Injury Risk.
• Gloves recommended
Burn Rate
Air Control
Start-Up
Air Control
Figure 9.1
Pull Forward
to Shut Down
Figure 9.2
7039-185A
2100 Millennium AU Wood Appliance
CAUTION
HIGH
MED
LOW
Manual
Timer (ACC)
Shut Down
Figure 9.3
9