Sony DCR-HC52/HC54 Operating Manual page 56

Troubleshooting (Continued)
You cannot dub correctly using the
A/V connecting cable.
• The A/V connecting cable is not connected
properly. Make sure that the A/V
connecting cable is connected to the input
jack of another device for dubbing a picture
from your camcorder (p. 44).
New sound added to a recorded tape
is not heard.
• Adjust [AUDIO MIX] until the sound is
heard appropriately (p. 36).
Pictures from connected devices are
not displayed correctly.
• The input signal is not NTSC (p. 59).
Connecting to a computer (DCR-
HC54)
The computer does not recognize
your camcorder.
• Install the "Picture Motion Browser"
(p. 49).
• The computer may not recognize your
camcorder for a few moments after you
connect it. Wait for a while.
• Disconnect USB devices other than the
keyboard, the mouse, and the camcorder
from the (USB) jack on the computer.
• Disconnect the cable from the computer
and camcorder, restart the computer, then
connect them again correctly.
You cannot install the supplied
software, "Picture Motion Browser,"
on a Macintosh computer.
• You can install "Picture Motion Browser"
only on a Windows computer.
56
Functions that cannot be used
together
Depending on the functions, you may not
be able to use them together. The following
list shows examples of functions that
cannot be used at the same time.
Not available If this function is set
backlight [SPOT METER],
[EXPOSURE]
[SPOT FOCUS] [SCENE SEL.]
[SPOT METER] NightShot plus
[SCENE SEL.] NightShot plus
[EXPOSURE] NightShot plus
[WHT BAL] NightShot plus