Advertisement
ZN-7100-DE500-G V2
802.11ac Wireless Access Point
Quick Setup Guide
This Quick Setup Guide provides step-by-
step instructions on how to set up your ZN-
7100-DE500-G V2 Wireless Access Point.
After completing the steps described in
this guide, you will be able to place the AP
at your site and provide wireless network
access to users.
PACKAGE CONTENTS
• ZN-7100-DE500-G V2 Wireless
Access Point (1)
• Mounting screws and bracket (1)
• RJ-45 Ethernet cable (1)
HARDWARE OVERVIEW
Front View
LED Indicators on the Device
No
LED
State
Off
1
PWR
Green
On
Off
2
WLAN
Blinking
Green
Off
Green
3
LAN
On
Blinking
Green
Bottom View
Description
No.
1
No power to AP
AP power on, device
Rear View
ready
2.4G radio disabled
2.4G radio enabled
or data being
forwarded
Ethernet port not
connected
No.
Ethernet port
connected
1
Ethernet link activity
2
3
4
5
Item
Mounting Bracket Hooks
1
2
3 4
5
Item
Ground
LED
PoE/LAN Port
Reset Button
LAN Port (Option)
Advertisement
Table of Contents
Related Manuals for ZComax ZN-7100-DE500-G V2
Summary of Contents for ZComax ZN-7100-DE500-G V2
-
Page 1: Quick Setup Guide
Mounting Bracket Hooks No power to AP PACKAGE CONTENTS Green AP power on, device Rear View • ZN-7100-DE500-G V2 Wireless ready Access Point (1) 2.4G radio disabled • Mounting screws and bracket (1) 2.4G radio enabled WLAN •... -
Page 2: Setup Requirements
SETUP REQUIREMENTS STEP 4: CONFIGURE THE AP 1. Insert one end of an Ethernet cable to the Before installing your ZN-7100-DE500-G V2 access LAN port on the Access Point. The procedure for completing the Access point, be sure that you have the following: 2. - Page 3 Configuring for Standalone Operation 1. Once login, first assign a fixed IP address Before configuring fat AP Basic settings, make or a DHCP IP to the AP under Current IP sure that AP mode is set to Fat AP. Setting. Under Wireless Switch Setting, select Connect With Wireless Switch Via 1.
-
Page 4: Step 4: Verify The Connection
4. Configure the common RF setting as such STEP 5: INSTALL THE AP Country/Region domain and Channel. 1. Disconnect the AP’s power adapter from the 5. Click Apply to save the changes. power outlet (or disconnect the PoE cable). 2. Move the AP to its permanent location (accessible to both power source and network connections). -
Page 5: Step 7: Power And Connect
If you are using AP Controller to manage the AP, please refer to the AP Controller user guide to learn how to configure and manage the AP from the AP Controller Web interface. The latest versions of user manuals are available for download on the ZDC website at: www.zcom.com.cn Copyright ©...
Need help?
Do you have a question about the ZN-7100-DE500-G V2 and is the answer not in the manual?
Questions and answers