Table of Contents
Advertisement
Quick Links
ZLF-372 LTE-Fi Access Point
Quick Installation Guide
This Quick Setup Guide provides step-by-step
instructions on how to set up your ZLF-372 LTE-
Fi Access Point. After completing the steps
described in this guide, you will be able to place
the AP at your site and provide wireless
network access to users.
PACKAGE CONTENTS
ZLF-372
Mounting Kit
Security Plate & Cable Cover
Screw Kit
HARDWARE OVERVIEW
3D View
Power Cable
LTE & GPS Antennas
Bottom View
No
Item
1
Power
2
LED Indicators
3
Console Port
4
LTE Antennas
Side View
No
Item
1
RF-45 Ethernet Port
2
GPS Antenna
3
SIM Card Slot
4
Reset Pinhole
Advertisement
Table of Contents
Related Manuals for ZComax ZLF-372
Summary of Contents for ZComax ZLF-372
-
Page 1: Quick Installation Guide
ZLF-372 LTE-Fi Access Point Quick Installation Guide This Quick Setup Guide provides step-by-step instructions on how to set up your ZLF-372 LTE- Fi Access Point. After completing the steps described in this guide, you will be able to place the AP at your site and provide wireless network access to users. -
Page 2: Setup Requirements
Once you have an activated SIM (Mini SIM), with the Ethernet and USB slots on the ZLF- insert it into the SIM slot of ZLF-372. Be sure to 372. insert the card with the notch-end first and the gold contacts facing down –... -
Page 3: Step 2: Connect The Antennas
2. Position the antennas so they suit your deployment scenario. STEP 3: ATTACH THE CABLE COVER The ZLF-372 comes with a plastic cable cover to hide AP’s power and antenna connectors to prevent removal of power and antenna cables. 3. Secure the plate with two screws (without 1. -
Page 4: Step 4: Mount The Access Point
STEP 4: MOUNT THE ACCESS POINT MOUNTING ON A POLE 1. Select a pole where the power is available The ZLF-372 can be mounted to a pole or any nearby to mount the access point. You can flat surface on the vehicle using the supplied attach the access point to any pole from 29 mounting brackets and screws. -
Page 5: Mounting On A Flat Surface
MOUNTING ON A FLAT SURFACE 8. Insert the M5xL40 screw into the drilled 1. Attach the bracket ① on the ZLF-372 using hole and use the nut to tighten to secure the four M5xL10 screws. bracket pole. -
Page 6: Step 5: Connect The Power
STEP 6, STEP 7 and STEP 8 and go to Power Cord STEP 9 to proceed. STEP 6: CONNECT THE AP TO YOUR To configure the ZLF-372 as FAT AP, please do the following: 1. Insert one end of an Ethernet cable to the Wire Colors Description Ethernet port on the ZLF-372. -
Page 7: Step 7: Log Into The Ap
Click Apply to save changes. 4. Go to RF Configure > Wireless Settings. Copyright © 2016 Zcomax Technologies, Inc. All rights reserved. (For dual band 5G setting, select Card 2 first All other company and product names mentioned in the documentation are held to be trademarked (and registered) by then go to RF Configure >...